This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

APX 320 not updating firmware and still restarting

hello,

 

i want to ask about APX 320. We have 13 pieces of this machine. 12 from them i update, pair with XG and they are runing fine. But one of them after connected to net, like 12 before, it still restarting. i tried to connect via console (picture1). there is problem with kernel image.

do I have to complain about the device to the seller? is there a possible setting to fix the problem?

 

4426.picture1.txt
U-Boot 2012.07 (Dec 05 2017 - 16:05:06)

smem ram ptable found: ver: 1 len: 3
DRAM:  512 MiB
machid : 0x8010006
NAND:  ONFI device found
ID = 9590dcc2
Vendor = c2
Device = dc
SF: Detected GD25Q32 with page size 4 KiB, total 4 MiB
ipq_spi: page_size: 0x100, sector_size: 0x1000, size: 0x400000
516 MiB
In:    serial
Out:   serial
Err:   serial
machid: 8010006
flash_type: 0
Configurate GPIO setting
Configurate TPM reset from low to high.
Configurate BLE reset from low to high.
Net:
PHY ID = 0x4dd072, eth0 found AR8035 PHY
MAC0 addr:7c:5a:1c:1:c5:b0
eth0
Creating 1 MTD partitions on "nand0":
0x000000000000-0x000020000000 : "mtd=0"
UBI: attaching mtd2 to ubi0
UBI: physical eraseblock size:   131072 bytes (128 KiB)
UBI: logical eraseblock size:    126976 bytes
UBI: smallest flash I/O unit:    2048
UBI: VID header offset:          2048 (aligned 2048)
UBI: data offset:                4096
UBI: attached mtd2 to ubi0
UBI: MTD device name:            "mtd=0"
UBI: MTD device size:            512 MiB
UBI: number of good PEBs:        4095
UBI: number of bad PEBs:         1
UBI: max. allowed volumes:       128
UBI: wear-leveling threshold:    4096
UBI: number of internal volumes: 1
UBI: number of user volumes:     3
UBI: available PEBs:             2167
UBI: total number of reserved PEBs: 1928
UBI: number of PEBs reserved for bad PEB handling: 40
UBI: max/mean erase counter: 11/1
SF: Detected GD25Q32 with page size 4 KiB, total 4 MiB
Hit any key to stop autoboot:  0
Read 0 bytes from volume image to 88000000
No size specified -> Using max size (67170304)
Wrong Image Format for bootm command
ERROR: can't get kernel image!
Read 0 bytes from volume image_backup to 88000000
No size specified -> Using max size (67170304)
Wrong Image Format for bootm command
ERROR: can't get kernel image!
eth0 PHY0 up Speed :1000 Full duplex
err:magicword 200
Status packet sent after ARP request
data abort
pc : [<8733e7e0>]          lr : [<8733e794>]
sp : 871efc38  ip : 00000000     fp : 00000000
r10: 8735e14f  r9 : 00000000     r8 : 871eff60
r7 : 88000000  r6 : 00000000     r5 : 871efc54  r4 : 88000000
r3 : fffffff8  r2 : 00000004     r1 : 00000000  r0 : 87ffffff
Flags: NzCv  IRQs off  FIQs off  Mode SVC_32
Resetting CPU ...

resetting ...

Format: Log Type - Time(microsec) - Message - Optional Info
Log Type: B - Since Boot(Power On Reset),  D - Delta,  S - Statistic
S - QC_IMAGE_VERSION_STRING=BOOT.BF.3.1.1-00108
S - IMAGE_VARIANT_STRING=DAABANAZA
S - OEM_IMAGE_VERSION_STRING=CRM
S - Boot Config, 0x00000021
S - Reset status Config, 0x00000010
S - Core 0 Frequency, 0 MHz
B -       261 - PBL, Start
B -      1338 - bootable_media_detect_entry, Start
B -      1678 - bootable_media_detect_success, Start
B -      1692 - elf_loader_entry, Start
B -      5068 - auth_hash_seg_entry, Start
B -      7209 - auth_hash_seg_exit, Start
B -    578513 - elf_segs_hash_verify_entry, Start
B -    694666 - PBL, End
B -    694690 - SBL1, Start
B -    785007 - pm_device_init, Start
D -         7 - pm_device_init, Delta
B -    786532 - boot_flash_init, Start
D -     57471 - boot_flash_init, Delta
B -    848146 - boot_config_data_table_init, Start
D -      3843 - boot_config_data_table_init, Delta - (419 Bytes)
B -    855359 - clock_init, Start
D -      7578 - clock_init, Delta
B -    867436 - CDT version:2,Platform ID:8,Major ID:1,Minor ID:0,Subtype:6
B -    870850 - sbl1_ddr_set_params, Start
B -    875946 - cpr_init, Start
D -         2 - cpr_init, Delta
B -    880329 - Pre_DDR_clock_init, Start
D -         5 - Pre_DDR_clock_init, Delta
D -     13176 - sbl1_ddr_set_params, Delta
B -    893643 - pm_driver_init, Start
D -         3 - pm_driver_init, Delta
B -    964275 - sbl1_wait_for_ddr_training, Start
D -        28 - sbl1_wait_for_ddr_training, Delta
B -    980667 - Image Load, Start
D -    138422 - QSEE Image Loaded, Delta - (269176 Bytes)
B -   1119521 - Image Load, Start
D -      1443 - SEC Image Loaded, Delta - (2048 Bytes)
B -   1129822 - Image Load, Start
D -    220161 - APPSBL Image Loaded, Delta - (450356 Bytes)
B -   1350381 - QSEE Execution, Start
D -        60 - QSEE Execution, Delta
B -   1356598 - SBL1, End
D -    663986 - SBL1, Delta
S - Flash Throughput, 2006 KB/s  (721999 Bytes,  359838 us)
S - DDR Frequency, 672 MHz

 

 

thanks

 

matej

 



This thread was automatically locked due to age.