Integrating an XG210 with an existing Ubiquiti Unifi Network with multiple VLANs.

Question

I am trying to integrate an XG210 into an existing network. The network is a full Ubiquiti Unifi setup and has multiple VLANs set up between the gateway and the switch. I would think I could place the XG in line on a trunk connection between the switch and the gateway. The end goal is to be able to filter the individual networks separately in regards to web filtering and scanning etc. 
 I have asked this question before and got a lead: "You would have to set up virtual interfaces for all the VLANs and bridge them accordingly." But was unsuccessful in making this work. 
 I am new to the XGs having come from sonicwall, so I am still a bit green when it comes to using the XG software. Can anyone give me a bit more detailed instructions, or at least a link or two to something to help me figure this out? Any help will be appreciated.

lferrara · Accepted Answer

Paul, 
 good work! To be able to allow only certain VLAN, create the VLAN network and then add it to source network inside the LAN to WAN rule or any other policy rule and that VLAN will be allowed. 
 Thanks

lferrara · Answer

No. Create a network object directly from the source network inside the LAN to WAN policy. Create the VLAN as subnet. 
 Thanks

Aditya Patel · Answer

HI Paul, 
 Welcome to Sophos , I would advise to contact the partner you have purchased the device from to help you with your migration . I am sure they are able to help . Let me know if they could not provide you assistance in such matter .