SNMP acces to spesific ip adreses

Question

Hi; 
 I want to do monitoring from snmp service but I don't want to open snmp service to the all world , I only want to allow snmp to the specific ip adress. 
 for this process; 
 I am going to system -> administration -> snmp and activated the snmp service and added only the ip address which I want to allow to the SNMPv1 and v2c community and traps option , and I created a firewall rule on the wan side. 
 despite all this ,I cannot get data from snmp. 
 But , when i goes to system -> Administration -> device access and enable snmp for to wan zone snmp data is coming but this way I open the snmp protocol to the whole world. 
 where do you think I'm going wrong or does sophos not have such a feature? 
 
 Thanks.

Vishal_R · Answer

Hi Ozan Can Please also check the below thread where this similar concern was discussed:

SNMP from Outside

So if you enable SNMP on the WAN zone still you will only be able to generate SNMP query and trap from the SNMP Manager IP Address which has been defined under "System > Administration > SNMPv1 and v2c community and traps > Source" along with the specific “community” string used in configuration.

Vivek Jagad · Answer

Hello Ozan Can ,

Thank you for reaching out to the community, to allow service of SNMP via ACL is a feature request valid for future consideration in the product's roadmap: SFSW-I-1115. As of now no ETA Planned.

SNMP acces to spesific ip adreses

Top Replies