It seems to be using a lot less RAM. Been running 3.5 hours and averaging 67% RAM usage. Usage goes up over time, so it may settle in at a higher average, but v18.5 was using about 75% on average and v19 GA was using about 80% on average, for me.
Had a crash of v19 GA this afternoon where the blue (storage) light blinks like crazy and I slowly lose capabilities until the AP goes orange, etc and have to reboot. (This has happened maybe once a month for me, maybe once every two months.) Hopefully fixed in v19 MR1.
Just checked my machine. Before upgrading memory was stable around 70%, since the upgrade it climbed to now being 78%
I'll keep monitoring this.
There does appear to be a memory leak with this build or something going on. I started around 45% memory usage after upgrading. Now I’m sitting at 90% memory usage after four days of uptime. I’m usually around 50-60% with the previous build.
Could you please send us a Screenshot of the webadmin and the memory consumption?
Also check via atop on the CLI, which process is consuming so much memory.
Does any of those time values match with the sudden increase of the RAM?
You see the run time and the increase seems to be some hours ago. Which process matches?
Looking at the memory usage graph, it appears the increase in memory was at 3:34 AM local time. It was around 9:00 AM local time when I looked at top, so about 5 hours and 30 minutes from the increase in memory usage. It looks like it was an increase of 1,437 MB and I none of the times in top seem to correspond to an increase around that time (just looking at what appears to be the uptime for each process in top).
I’ll keep letting it run for now to see what happens but I’ll reboot at some point if nothing changes and try to get some before and after screenshots.