This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Sophos APX / Clients cant get DHCP or active Connection / Bug

Hi,

i think i just found out a Bug and would like to ask if someone else expieriencing the same issue.

When i connect an already configured APX320 to the switch to power it up, it will get the newest config. But when i try to connect to the wifi it is sending, i wont get an DHCP, and when i set a manual IP, i am not able to communicate to the Firewall. The wifi is a seperate network, so no vlan bridging.

However when i remove the assigned wifi from the APX, wait till it updates and put it back again, it is working flawlessly.

I searched forever to find this out, but this seems like a bug. We have 24 APX320 and 3 APX740. I didnt try it yet with the 740. 

I have an XGS3100 with SFOS 19.5.0 GA-Build197. Firmware Pattern from the AP is on 11.0.020

I would like to know wether someone else has this, or is this something only happening at my site...



Added TAGs
[edited by: Erick Jan at 4:11 AM (GMT -8) on 12 Jan 2024]
Parents Reply Children
No Data