Greetings,
I've got 4 AP30 devices. One is doing just fine.
The other 3 were disconnected for a construction project.
I'm guessing there was an update to the AP30's while they were disconnected, and now they don't react to the UTM.
These 3 AP30's will not show up as active in the UTM portal.
I've looked at the DHCP log, and what I see is endless DHCPDiscovers and offers (shown below). 192.168.1.52 is a correct IP for this device. This is a VLAN'd interface, but it will time out, and then try the non-VLAN'd interface ETH0, with the same result (different IP address. but appropriate, is offered to ETH0). Nothing ever shows up in the DHCP Lease table.
Ideas??? - Thanks, Mark
This thread was automatically locked due to age.