Re-enable the Mgmt Port after Backup/Restore from a device that didn't have one

Hello,

Thank you for contacting Sophos Community!

You review below:

docs.sophos.com/.../index.html

Yes, I already review the document, this assumes you can get into the device, because the MGMT port has been disabled by the backup restore from the XG310, which didn't have a MGMT port, the MGMT port is now disabled.

I only have the MGMT port plugged in currently as I don't want the restored backup on the new XGS3300 to interfere with my currently running XG310s

So, I need to re-enable it from the console/adavanced shell and assign an IP address to it

Craig

how did you locally manage the XG before? this "old" interface should still exist. Eventually on a different port.  the mgmt interface will just appear in the interface list and can be configured as per your needs.

They were managed from the Lan Interface, via the LAN IP address as a dedicated MGMT port didn't exist on the XG310s

I like the idea of having a separate MGMT interface on the XGS3300 as this was how the out of the box setup/restore process was done through, the MGMT port also didn't show up in the SFOS 20 MR2 port mapping function else I would have remapped it there.

I can't plug the LAN port of the newly restored XGS3300 in as it will conflict with my XG310 LAN interfaces.

Craig

can't you just plug your notebook to the local LAN port of the machine?

I could if I had a fibre port on it, our LAN port is mapped to a SFP port.

I'll have to use the console to change the LAN IP of the XGS3300 I think, so I can plug it into the network. It's a bit of a ballache to have to do to re-nable the MGMT port, which is why I was hoping to setup the MGMT port via the Console/Advanced Shel

an idea: on XG310 - if you have: activate a free interface for admin management, backup and restore again on XGS.

I've managed to do it by temporarily changing the LAN IP from the console to something other than that on the running X310 pair, once in I configured the MGMT interface from there, did the same on the other new XGS3300 after it did the same thing during the backup restore. I've got them configured in HA now, just need to change the LAN IP back when I switch off the X310 pair.

So I've worked around the issue now

Thanks for your suggestions!

I've managed to do it by temporarily changing the LAN IP from the console to something other than that on the running X310 pair, once in I configured the MGMT interface from there, did the same on the other new XGS3300 after it did the same thing during the backup restore. I've got them configured in HA now, just need to change the LAN IP back when I switch off the X310 pair.

So I've worked around the issue now

Thanks for your suggestions!