Important note about SSL VPN compatibility for 20.0 MR1 with EoL SFOS versions and UTM9 OS. Learn more in the release notes.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 6 replies
  • Subscribers 40 subscribers
  • Views 6031 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Please advise how to block spam messages while using imaps and how to get smtp into the logviewer?

rfcat_vk

Hi folks,

a while ago I had issues with SASI not logging all iMaps traffic. The issue has been partially resolved by changing firewall mail rules.

A new issue is I receive over 1000 spam messages a day from the same sites via the mail post office address. I can't block the IP address because it is a valid mail server address fro genuine messages.

The question is, how do I use the XG to block the unwanted traffic? Further I will be following up with the mail service as to why their spam engine reports the messages as not spam.

Next item, how to get user sent messages using SMTP into the logs and be reported daily? The XG sent daily reports show in the daily reports.

Ian



This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to JanosRapcsak

    Hi,

    I have PM'ed you asking for a progress report and not received any advice regarding the Imaps traffic you were investigating and I have not received any advice on the SMTP issue.

    Ian

    XG115W - v20.0.2 MR-2 - Home

    XG on VM 8 - v21 GA

    If a post solves your question please use the 'Verify Answer' button.

  • 0 in reply to rfcat_vk

    Could part of the answer be that SASI does not work on IPv6 traffic?

    Ian

    XG115W - v20.0.2 MR-2 - Home

    XG on VM 8 - v21 GA

    If a post solves your question please use the 'Verify Answer' button.

  • 0 in reply to rfcat_vk

    Hi foks,

    further investigation  and questions. I note that in both IP4 and IPv6 mail messages the XG translate the 993 to 992, could this be the reason why SASI is not scanning messages? I have highlighted the DST port in red.

    mail proxy.docx

    Ian

    XG115W - v20.0.2 MR-2 - Home

    XG on VM 8 - v21 GA

    If a post solves your question please use the 'Verify Answer' button.

  • 0 in reply to rfcat_vk

    No-one else has this issue? Hopefully the issues will be resolved with v20.0.1 mr-1?

    Ian

    XG115W - v20.0.2 MR-2 - Home

    XG on VM 8 - v21 GA

    If a post solves your question please use the 'Verify Answer' button.

Unfiltered HTML