Nueva linea SG/XG Hardware: Cuales son los Puertos ByPass o Failopen incluidos

Hi Jaime,

Thanks for reaching out with your suggestion!

Maybe you are looking for this KBA? Sophos XG Firewall: LAN/Hardware Bypass Mode​

• By default, LAN Bypass Mode is disabled and is required to be enabled via command line.
• In this mode, one or two pairs of interfaces are bridged allowing uninterrupted traffic flow
• The LED on the front panel of the appliance blinks RED when Bypass Mode is active.​
• This datasheet​ outlines the location of the bypass pairs.

Did you have any suggestions on how we can improve this existing article?

Regards,

Hello,

Hello,

It is necessary to indicate that only in this document indicates which ports are the bypass

https://www.sophos.com/en-us/medialibrary/PDFs/documentation/SophosXGFirewall/sophos-operating-instructions-xg-210-rev3-230-rev2-oina.pdf

https://www.sophos.com/en-us/medialibrary/PDFs/documentation/SophosXGFirewall/sophos-operating-instructions-xg-310-330-rev2-oina.pdf

Regards

Thank you for sharing this suggestion! I'll forward this feedback to our KBA team and reach out to you when I receive an update.

Regards,

Hi Jaime Tan 

Thank you again for reaching out with your suggestion!

Our KBA team has updated the article to include a note in the prerequisites section to refer to the appropriate Quick Start Guide to locate the designated LAN bypass ports: 

• Sophos XG Firewall: LAN/Hardware Bypass Mode

To say thanks, I have sent you a PM with a $20 voucher code to our Sophos Store!

Regards,