This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SSL VPN: Client to Client communication

Dear everybody,

I have currently implemented an SSL Client VPN which works perfectly fine for my routed networks (tunnel).

I am wondering how it is possible to have the VPN IP Pool ( 10.242.2.x ) routed through the tunnel as I want to have the possibility to communicate whith each connected VPN client vice versa.

Once I add the VPN IP Pool to the Local Network group my client starts not being able to connect to the astaro gateway anymore.

Any thoughts on this ?

Thanks in advance.

Lars

This thread was automatically locked due to age.

Parents

0 BAlfson over 14 years ago

I've thought a bit more about this, and would be interested to know if the following NAT "trick" works:
VPN Pool (SSL) -> Any -> VPN Pool (SSL) : SNAT from Internal (Address) {leave 'Source service' blank!}

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 janosch over 14 years ago in reply to BAlfson

Hi,

I've thought a bit more about this, and would be interested to know if the following NAT "trick" works:
VPN Pool (SSL) -> Any -> VPN Pool (SSL) : SNAT from Internal (Address) {leave 'Source service' blank!}

Cheers - Bob

Hi,

does not work. :-(

kind regards

jan
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 janosch over 14 years ago in reply to BAlfson

Hi,

I've thought a bit more about this, and would be interested to know if the following NAT "trick" works:
VPN Pool (SSL) -> Any -> VPN Pool (SSL) : SNAT from Internal (Address) {leave 'Source service' blank!}

Cheers - Bob

Hi,

does not work. :-(

kind regards

jan
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data