Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 7 replies
  • Answers 2 answers
  • Subscribers 3 subscribers
  • Views 21839 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Vonage configuration

manipal

Hi 

I just built and configured my UTM with the home license. I use vonage at home and it stopped working after implementing UTM9. Vonage box is getting the IP address ( I am using DHCP server in the UTM). What VoIP rules do I need to setup to let the traffic through for vonage?  If someone can please give me step by step instructions as I am still learning about the UTM's.

Thanks



This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to sachingurung

    Unknown said:

    Please refer the link to configure SIP protocol in UTM.

    https://www.sophos.com/support/knowledgebase/120284.aspx

    Please note:  The KB references SIP signalling on 5060, Vonage uses 5061.

    -- From Vonage --

    SIP: Port 5061 UDP (Used to send and receive SIP information)

    RTP: Ports 10000-20000 UDP. (Used to send and receive RTP traffic) When a call is made, random ports between 10000 and 20000 are used to carry the conversation. If any of these ports are blocked, you may experience one way or no audio.

Unfiltered HTML