This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Hardware logging not working (UTM220 rev5 - 9.004-34)

Hello,

I just upgraded from v8/rev2 220's to v9/rev5 220's. Everything went smooth, but I noticed that if I got to Logging & Reporting > Hardware, the graphs all show 0% flat. On the Dashboard Resource Usage, however, it shows (e.g.) 8% cpu, 82% of 2GB ram, 7% log disk, and 10% data disk.

Any ideas on why the graphs in the logging and reporting section are not working?

This thread was automatically locked due to age.

Parents

0 BAlfson over 12 years ago

Please note that I have corrected my post above, adding the key command: /etc/init.d/rrdcache restart

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BAlfson over 12 years ago

Please note that I have corrected my post above, adding the key command: /etc/init.d/rrdcache restart

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data