This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

New Setup

I have UTM 9.7, and setup on a inexpensive PC, with 8GB memory/1TB drive, an motherboard Intel Ethernet eth0 and dual-port Intel Ethernet NIC (eth1/eth2).

Setup with eth0 as 10.0.0.2, Can connect to WebAdmin interface from 10.0.0.2:4444, and registered the "home only" license. The eth1 connection in the console shows the link up for eth1 connected to the ISP.

However, when trying to use the Win10 client (previously used for the UTM home WebAdmin interface) cannot http to any other URL.

Rather than move question by question, is there an installation guide for the UTM home setup/use?

This thread was automatically locked due to age.

Top Replies

dirkkotte 3 months ago +1

Hi Lawrence, The start-wizzard should create a working configuration. (You need DNS, a firewall-Rule allowing access to "internet" and a NAT/masquerading rule) You may search for the "sophos utm…

Parents

0 dirkkotte 3 months ago

Hi Lawrence,

The start-wizzard should create a working configuration.

(You need DNS, a firewall-Rule allowing access to "internet" and a NAT/masquerading rule)

You may search for the "sophos utm quick start guide" ... https://gzhls.at/blob/ldb/a/f/a/d/84833477947c8ad0e5f1a768f74c28bd88a1.pdf

Config guide: https://docs.sophos.com/nsg/sophos-utm/utm/9.717/help/en-us/Content/utm/utmAdminGuide/InstallationBasicConfiguration.htm

Admin guide: https://docs.sophos.com/nsg/sophos-utm/utm/9.6/pdf/en-us/administration-guide-9.600.pdf

BTW, Sophos UTM is EOL in 2026. You should consider testing the current Sophos-XG-firewall. There is a home version/licence too.

https://www.sophos.com/en-us/free-tools/sophos-xg-firewall-home-edition

Dirk

Systema Gesellschaft für angewandte Datentechnik mbH // Sophos Platinum Partner
Sophos Solution Partner since 2003
If a post solves your question, click the 'Verify Answer' link at this post.
Cancel
Vote Up +1 Vote Down

Cancel
0 Lawrence Grim 3 months ago in reply to dirkkotte

Dirk,

Thank you for the UTM administration guide. However, after getting connected to the eth0 WebAdmin console, installing the license, and showing the ISP connecting on eth1, still cannot go from the workstation on the LAN to the internet through the UTM (workstation >eth0, but not through to ISP at eth1).

Does that make sense?

Larry
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Lawrence Grim 3 months ago in reply to dirkkotte

Dirk,

Thank you for the UTM administration guide. However, after getting connected to the eth0 WebAdmin console, installing the license, and showing the ISP connecting on eth1, still cannot go from the workstation on the LAN to the internet through the UTM (workstation >eth0, but not through to ISP at eth1).

Does that make sense?

Larry
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data