TPG Fibre 400 on a SG210

Hi Paul,

Check #7 in the Rulz by Bob. Any help?

Take SSH to the UTM and run ifconfig to verify if there are Dropped/Error packets observed on the WAN interface; show us the output.

Finally, check the internet speed received on the UTM directly, execute: 

wget --no-check-certificate -O - raw.githubusercontent.com/.../speedtest.py | python

Thank You

Thanks for the replys.

I have checked routes there are no manual routes.

i have also run the python script. Results below.

Those are the results i would expect on speedtest.net

Thankyou

Thanks for the replys.

I have checked routes there are no manual routes.

i have also run the python script. Results below.

Those are the results i would expect on speedtest.net

Thankyou

Hi, Paul, and welcome to the UTM Community!

Paste the following block in at the command line to see the difference between without and with Snort:

cc set ips status 0
sleep 15s
python speedtest.py
cc set ips status 1
sleep 30s
python speedtest.py

You should see a difference with IPs off (0) vs. on (1).  Since Snort is a single-threaded process, you're only testing one of the two dual processors.  If you'll run two or more tests simultaneously behind the SG 210 with Snort on, I think you'll see full utilization of your bandwidth.

Cheers - Bob