How can I setup multipath rules ?

Hello Patrick ,

Thank you for reaching out to the community, please refer Uplink Balancing and Multipath rules.

I already read your post before asking here. I didn't solve my problem.

You have configured it correctly i.e.,, by binding it by interface, did you tried clearing the conntrack and then check whether the service uses WAN 2 and not WAN 1 ?

How do I clear the conntrack? So, I want when the  WAN 2 is down the first rule Transmission (port 51413)  does not connect to wan1.

refer Delete conntrack command.

I saw it. I don't undertand it. I type 192.168.10.4 is the host for my laptop and 192.168.10.1 is the gateway

conntrack -L --src 192.168.10.4 --dst 192.168.10.1 -p tcp

then I type

conntrack -D --src 192.168.10.4 --dst 192.168.10.1 -p tcp

then stuck this command in shell.

What I am doing wrong??

Hey Patrick  to delete from source -  #conntrack - D -s <ip.address> or (destination) #conntrack - D -d <ip.address>

I did it. I don't know if I deleted correct source but I deleted. The same error.  I didn't solve it.

Please log a service request, will help expedite the service request. 

I found the ip with conntrack --event ( real-time event log ) So , is there a way to setting up internal network using ONLY - SPECIFIC wan?

Can I do it with static routing?

Vivek I want 51413 to use only one wan. Can I do it?

Thank you

Hey Patrick ,
You can mention the internal network and the service under the multipath:

And Also under the Network Protection > NAT > Masquerading 
Create a rule mentioning that internal network position top and select that specific WAN:

Hey Patrick ,
You can mention the internal network and the service under the multipath:

And Also under the Network Protection > NAT > Masquerading 
Create a rule mentioning that internal network position top and select that specific WAN: