Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 7 replies
  • Answers 2 answers
  • Subscribers 14 subscribers
  • Views 3106 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to disable a radio in an APX120

rfcat_vk

Hi,

I want to disable the 2.4ghz radio in my APX120 because it is interfering with other devices? I have set the power to 10%, but that is not the answer.

Ian



This thread was automatically locked due to age.
Parents Reply
  • 0 in reply to Tejas Kashyap

    Thank you for replying, but that does not appear to be true in this case. The only way to stop the 2.4ghz radio interfering is by powering off the AP.

    Ian

    XG115W - v20.0.2 MR-2 - Home

    XG on VM 8 - v21 GA

    If a post solves your question please use the 'Verify Answer' button.

Children
  • 0 in reply to rfcat_vk

    Hi, Can you provide a bit more info on this? How are you measuring interference here? The implementation is such that if no SSIDs are mapped, the radio will not beacon or emit anything. So, this should not interfere with other networks or devices that operate on the same frequency. 

  • 0 in reply to Tejas Kashyap

    I am not measuring the radiation, just two of my IoT devices fail to connect when the ap is enabled. Thankfully this ap will only be used on very rare occasions so I can accept the issue at the time.

    ian

    XG115W - v20.0.2 MR-2 - Home

    XG on VM 8 - v21 GA

    If a post solves your question please use the 'Verify Answer' button.

  • 0 in reply to rfcat_vk

    I have identified the cause, now to locate the AP that is scanning and causing the drops.

    Ian

    XG115W - v20.0.2 MR-2 - Home

    XG on VM 8 - v21 GA

    If a post solves your question please use the 'Verify Answer' button.

Unfiltered HTML