Important note about SSL VPN compatibility for 20.0 MR1 with EoL SFOS versions and UTM9 OS. Learn more in the release notes.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 6 replies
  • Subscribers 41 subscribers
  • Views 15746 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

I have issue regarding Sophos 100C AP the are taking more time to active in XG 310 firewall

OnkarAswale

Dear All,

               I am using XG 310 firewall from DHCP it are allocated.  It show in pending list I accepted it. Few are activated few are still in inactive mode I wait more than 10 hour 



This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to vilic
    Thank you sir but it is enable on the physical port
  • 0 in reply to OnkarAswale

    If you can, please disable STP on switch physical port that connects your AP with the rest of the network. In my experience, working with the new Sophos AP access points models (AP15 and AP55C), they tend to boot very quickly before STP algorithm on switch devices was finished.

    Cisco device switch: ORANGE blinking
    Sophos AP: series of ORANGE, then 4-5 times GREEN and than reboot. In that 4-5 packets AP tried to contact UTM, and after failure reboot itself hoping that it will have more success next time.

  • 0 in reply to vilic
    Okey got it thank you...our firewall is connected to L3 layarr switch. From L3 we connected L2 switches , we connected AP on L2 switches ....So as per your suggestion I have configure STP only on L3 and L2 switch.... And I have disable STP on phical port where I connect AP
Unfiltered HTML