This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Creating VLAN on different zone than LAN - BUG

This morning I created additional zone on my XG at home, then I was trying to create VLAN on this zone. After clicking apply, nothing happens with no error.

Created another zone and attempt to create an additional VLAN, same issue.

So I created the VLAN on LAN zone then I moved the VLAN to the desired zone.

Where is the limitation? No error messages?

Thanks,

Luk

This thread was automatically locked due to age.

0 GregH over 8 years ago

Hi Luk
Good spot, thanks for raising this.
I've reproduced the same symptoms here. I'll do some further investigation into this and let you know the outcome
Greg
Cancel
Vote Up 0 Vote Down

Cancel
0 lferrara over 8 years ago in reply to GregH

Thank you Greg.
Let us know.
Cancel
Vote Up 0 Vote Down

Cancel
0 GregH over 8 years ago in reply to lferrara

Just a quick update on this. We do already have this logged as a bug and expect this to be fixed in a future update. I don't have a specific version number yet I'm afraid..

The issue isn't specific to custom zones, but instead occurs when creating a vLAN interface on any zone that doesn't have a remote HTTP/HTTPS device access enabled on it.
So another workaround for this would be to create the custom zone and enable HTTPS access from it (System > Administration > Device Access). This should allow the vLAN interfaces to be created and may help those that need to create a large number of vLAN interfaces in the short term.

Greg
Cancel
Vote Up 0 Vote Down

Cancel
0 lferrara over 8 years ago in reply to GregH

Thank you GregH.
Good to know that. Anyway for the moment I prefer to create additional VLAN to LAN zone then move the VLAN to proper zone.

Waiting for next XG release.
Luk
Cancel
Vote Up 0 Vote Down

Cancel
0 Maintennace365IT over 8 years ago in reply to lferrara

Is this bug serious ?
In my case i create 1 zone by VLAN...
Nothing works ... same case you all ??
Cancel
Vote Up 0 Vote Down

Cancel
0 lferrara over 8 years ago in reply to Maintennace365IT

Yes Maintenance.
If you need to create VLAN, choose as zone the LAN then move to the desired zone.

Luk
Cancel
Vote Up 0 Vote Down

Cancel
0 Maintennace365IT over 8 years ago in reply to lferrara

seems to not work for me ... I created a physcal interface ( that i will not use ) and a vlan interface associated on this physical interface on LAN ZONE. Then move to ZONE VLAN21 and still not work... I will invistigate this. Thanks for work around lferrara, i have noticed this.
Cancel
Vote Up 0 Vote Down

Cancel