This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Trigkey G5

I have a Trigkey G5 minpc with dual Intel NIC. I am unable to install SFOS 20 and can only get as far as the *SFOS Installer prompt then it just stays on a blank black screen.

Anyone had any success installing SFOS on this device, how did you do it, and is it compatible or am I wasting my time and should install another firewall?

Thanks,

William

This thread was automatically locked due to age.

Parents

0 Farshid 7 months ago

Make sure legacy bios/CSM boot is enabled on bios. SFOS installer does not support UEFI.
Cancel
Vote Up 0 Vote Down

Cancel
0 William Kirkwood 7 months ago in reply to Farshid

Thanks, I have enabled CSM but it seems as per rfcat_nk the i-225/6 are not supported. Is there any possibility of adding i-225 driver support to the image preinstall?
Cancel
Vote Up 0 Vote Down

Cancel
0 rfcat_vk 7 months ago in reply to William Kirkwood

Hi,

no that will not work, the XG install will over write it and it becomes a security issue with untested modifications to the firewall software.

Ian

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 rfcat_vk 7 months ago in reply to William Kirkwood

Hi,

no that will not work, the XG install will over write it and it becomes a security issue with untested modifications to the firewall software.

Ian

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data