This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Trigkey G5

I have a Trigkey G5 minpc with dual Intel NIC. I am unable to install SFOS 20 and can only get as far as the *SFOS Installer prompt then it just stays on a blank black screen.

Anyone had any success installing SFOS on this device, how did you do it, and is it compatible or am I wasting my time and should install another firewall?

Thanks,

William

This thread was automatically locked due to age.

Parents

0 Farshid 7 months ago

Make sure legacy bios/CSM boot is enabled on bios. SFOS installer does not support UEFI.
Cancel
Vote Up 0 Vote Down

Cancel
0 William Kirkwood 7 months ago in reply to Farshid

Thanks, I have enabled CSM but it seems as per rfcat_nk the i-225/6 are not supported. Is there any possibility of adding i-225 driver support to the image preinstall?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 William Kirkwood 7 months ago in reply to Farshid

Thanks, I have enabled CSM but it seems as per rfcat_nk the i-225/6 are not supported. Is there any possibility of adding i-225 driver support to the image preinstall?
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 rfcat_vk 7 months ago in reply to William Kirkwood

Hi,

no that will not work, the XG install will over write it and it becomes a security issue with untested modifications to the firewall software.

Ian

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel
0 apijnappels 6 months ago in reply to William Kirkwood

Only option would be to virtualize your firewall on this hardware.

Managing several Sophos firewalls both at work and at some home locations, dedicated to continuously improve IT-security and feeling well helping others with their IT-security challenges.
Cancel
Vote Up 0 Vote Down

Cancel