This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

NOT RECEIVING THE INCOMING TRAFFIC FROM VPN TUNNEL

Hello guys,
I really need your help i am facing the challenge since am not receiving the traffic from remote machine i have attached the captured traffic and denied logs from the specific

machine....i can reach the remote machine by ping and telnet in time but only when i Curl the endpoint API of the server i can reach it but the response will take a time until i get Gateway time out....I am using Sophos XG115

This thread was automatically locked due to age.

Top Replies

Bharat J 7 months ago in reply to Jackson Awe +2 suggested

Please check by creating a test firewall rule from VPN-LAN with MASQ applied and keep the firewall rule and NAT rule on TOP as per the below step : Please go to Configure-->Routing-->Static routing…

0 rfcat_vk 7 months ago

How is the remote machine connected to the internet?

Ian

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel
0 Jackson Awe 7 months ago in reply to rfcat_vk

using VPN-SITE TO SITE
Cancel
Vote Up 0 Vote Down

Cancel
0 Bharat J 7 months ago in reply to Jackson Awe

Please check by creating a test firewall rule from VPN-LAN with MASQ applied and keep the firewall rule and NAT rule on TOP as per the below step :

Please go to Configure-->Routing-->Static routing and share current route if added.

Check the packet again after you created the above test rule.

Regards

"Sophos Partner: Networkkings Pvt Ltd".

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up +2 Vote Down

Cancel