HA Configuration Correct port must be monitored LAN port 1

Question

Whenever my LAN port switch restart my both the HA firewall restart why it happen

dirkkotte · Accepted Answer

I initially understood the problem differently too... But: If a monitored interface goes &ldquo;down&rdquo;, the firewall goes into &ldquo;FAILED&rdquo; status and stops processing traffic. Unfortunately, this also happens at the same time with the slave if both (master and slave) have a "monitored link down". ...unlike the SG firewall which keeps the last "working" node active

Vivek Jagad · Answer

Hey DevK ,

Thank you for reaching out to the community, cause you have your Port1 LAN under the monitored interface, and if any of them goes down, the firewall removes itself from the cluster, and a failover occurs. So here with the switch restart your Port1 fluctuates and hence firewall restarts...REF About HA.

Additionally also check if the following options in HA is enabled:

HA Configuration Correct port must be monitored LAN port 1

Top Replies