This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Sophos XGS chnage outgoing WAN Address

Hello,

We use several networks and several public IP addresses, which are stored as aliases on the WAN interface. How do I configure the NAT rule so that, for example, the public IP address xxx.xxx.xxx.xxx is used for network A and the address yyy.yyy.yyy.yyy.yyy is used for network B? We want to communicate with the Internet via different IP addresses. What would be the best solution for this?

Thank you!

This thread was automatically locked due to age.

Top Replies

LuCar Toni 7 months ago +1 suggested

For IP Change (ALIAS IPs on the same Interface) you can use a SNAT Rule. Simply create a SNAT and use the wanted IP as translated Source IP.

Parents

0 LuCar Toni 7 months ago

For IP Change (ALIAS IPs on the same Interface) you can use a SNAT Rule. Simply create a SNAT and use the wanted IP as translated Source IP.

__________________________________________________________________________________________________________________
Cancel
Vote Up +1 Vote Down

Cancel
0 admin_idl 7 months ago in reply to LuCar Toni

Thank you for the feedback. Do I also have to define settings for the incoming and outgoing interface? So that only the LAN to WAN traffic is taken into account or do these settings not have to be considered?
Cancel
Vote Up 0 Vote Down

Cancel
0 LuCar Toni 7 months ago in reply to admin_idl

Those are optional filter, can be set, but do not have to be set.

__________________________________________________________________________________________________________________
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 LuCar Toni 7 months ago in reply to admin_idl

Those are optional filter, can be set, but do not have to be set.

__________________________________________________________________________________________________________________
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data