XGS SSD Firmware - others also having issues HA nodes not coming up?

I started the SSD firmware update KB-000045380 on XGS136 HA A/P Cluster.

First I applied the update to the AUX node 2. It was successful and the machine re-entered the cluster and A/P cluster was all green in the end.

I switched the PRI HA node from node 1 to node 2 and waited until A/P cluster was all green again. So node 2 is now PRI.

The AUX node 1 is now down for 25min after the SSD update command has been given.

I'll wait until tomorrow and then power cycle it.

Anyone else having such circumstances?

XGS136_XN01_SFOS 19.5.3 MR-3-Build652 HA-Standalone# cish
console> system ha show details
 HA details
 HA status                           |   Enabled
 HA mode                             |   Active-passive
 Cluster ID                          |   0
 Initial primary                     |   X1310xxxxxBQ44 (Node1)
 Preferred primary                   |   No preference
 Load balancing                      |   Not applicable
 Dedicated port                      |   Port10
 Monitoring port                     |   -
 Keepalive request interval          |   250
 Keepalive attempts                  |   16
 Hypervisor-assigned MAC addresses   |   Disabled

 Local node
 Serial number (nodename)            |   X1310xxxxx8X84 (Node2)
 Current HA role                     |   Standalone
 Dedicated link's IP address         |   10.1.178.6
 Last status change                  |   09:41:15 PM, Jan 24, 2024

 Peer node
 Serial number (nodename)            |   X1310xxxxxBQ44 (Node1)
 Current HA role                     |   Fault
 Dedicated link's IP address         |   10.1.178.5
 Last status change                  |   09:41:15 PM, Jan 24, 2024



Edited TAGs
[edited by: Erick Jan at 1:16 AM (GMT -8) on 25 Jan 2024]
Parents Reply Children