Important note about SSL VPN compatibility for 20.0 MR1 with EoL SFOS versions and UTM9 OS. Learn more in the release notes.

Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 5 replies
  • Answers 1 answer
  • Subscribers 40 subscribers
  • Views 6687 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

XG-330 with 10gbps wan and lan ports slow download

Mike Smith9

Hi there.

I'm trying to deploy this XG330 into my home network with 10G expansion card for WAN and LAN (3gbps fiber internet).

If I test through the modem I get 3.2Gbps in and out.

If I put traffic through the XG330 I get initially 700mbps then it goes up to 1.2Gbps download and then 3Gbps upload.

IPS is disabled, advance threat protection disabled, web filtering everything disabled.

any ideas why the download is slow with all the stuff disabled? The specs sheet says 38gbps firewall speed supported (2.1gbps IPS)

Thanks!

M



This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to Mike Smith9

    both ports are 10000mbps full duplex with auto-config turned off. I will check the Switch to see if it's auto or forced.

    The firewall has indentified the following values based on the physical link it has detected.
    Link mode 10000 Mbps - Full-duplex
    Auto-negotiation for media type Off
    Forward Error Correction (FEC) Off
    Media type 74752-9520
    Cable vendor CISCO-MOLEX

  • 0 in reply to Mike Smith9

    its all 10g full duplex across the board. will check cpu usage during test.

    23% peak user during the incoming, 0.5% during the outbound portion of the test.

Unfiltered HTML