Way to change dhcp adresses within command line?

Hi,

why are you changing the IP address on Port 1?

Ian

No reason other than I want to. for the purpose of learning this aspect of the system.

If cli isn't possible maybe I can get some guidance on how to make it work?

I only have 2 NIC. 1 LAN 1 WAN.

I was able to change Port 2 to another LAN IP successfully and access the GUI via both ports. Trouble was accessing Proxmox GUI even though I could ping. So I switched everything back in Proxmox cli.

My end goal is to have 3 VLANs on my network, but I my current IP subnet to be one of the VLANs. First step is going to be changing the Port IP or figuring out VLAN setup. I'm attempting both currently.

Hello,

I recommend you register your Firewall on Sophos Central; once you can access the GUI via Central, change the IP of Port 1, and then try to access the GUI via the new IP assigned to Port 1.

Regards,

Thanks for the suggestion, are you implying that I can also adjust the DHCP via Sophos central? Changing the IP alone isn’t enough as the DHCP range is invalid once the IP is changed and effectively locked out. I can change the IP easy enough by CLI and GUI but I believe the issue is more with the DHCP server. 

I’ll try to plug into the nic and manually change my IP to fit the new gateway subnet. Not sure that will work as there’s no DHCP. But I don’t fully understand all this networking stuff and am learning new stuff everyday. 

I’ll try to plug into the nic and manually change my IP to fit the new gateway subnet. Not sure that will work as there’s no DHCP. But I don’t fully understand all this networking stuff and am learning new stuff everyday.