Important note about SSL VPN compatibility for 20.0 MR1 with EoL SFOS versions and UTM9 OS. Learn more in the release notes.

Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 38 subscribers
  • Views 778 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How WAN load balancing work on HA mode

RichardLeong

Hi,

I wonder how the sophos WAN load balancing work on HA mode.

I have 2 wan links 800Mbps/200Mbps up/down connected to port2 & port3,

after enable Weighted Round Robin the speed test show 932Mbps download and 423Mbps upload which is fine it show the speed of connections has doubled on upload and more then 800Mbps for download.

And I understood  that can't get 1600mbps download is because limited by physical port gigabit link.

My question is why I had configured HA active-active mode also can't get higher speed?

Both unit same model 135 HA status show up and running no problem, tested fail-over to another unit also fine.

The thing is how can I show to clients that both units under HA is load balancing. And this is why you need to pay double the subscriptions fee.



This thread was automatically locked due to age.
  • 0

    RichardLeong,

    you can try to monitor both XG wan ports by using the iftop -i "interfacename" command from advanced shell from both XG and show that both are handling WAN traffic.

    Otherwise, you can use the live connections TAB from XG UI interface while you are connected to both primary and secondary XG https IP address.

    Regards

Unfiltered HTML