Important note about SSL VPN compatibility for 20.0 MR1 with EoL SFOS versions and UTM9 OS. Learn more in the release notes.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

XG Software Appliance fails running Version 18 and get's into a boot Loop

Hi,

 

since today my Software XG is failing to boot up, it is stuck in a Bootloop.

The following Messages are shown while Booting:

This Problem also does not get solved by reinstallation, after entering the Licensenumber, the device gets into the Bootloop.

I've already checked RAM and the SSD for defects, but they are not defect.

Since I am XG Home User I can't open a case with Support.



This thread was automatically locked due to age.
Parents Reply Children
  • Thank you for your answer, but this screenshot is only a Example, sorry for the misleading Title, I've edited it.

    I've tried Updating from 17.5.9, from 17.5.10 and directly installing V 18, but the Problem is the same.

    So the Problem is obviously not the Update from V 17.5.10 to V 18, the Problem generally exists as soon as V 18 is running.

    Here a screenshot after the installation of V 18:

    Some seconds after the Appliance is in the State of the picture above, it reboots.

    Any Ideas?

    _______________________________________________

    Sophos XG User

  • Hi Dwayne,

    What hardware are you using? Did you upgrade the BIOS?

    Ian

    XG115W - v20.0.3 MR-3 - Home

    XG on VM 8 - v21 GA

    If a post solves your question please use the 'Verify Answer' button.

  • Hi,

     

    I am using a i5-3570, 6Gb DDR3 RAM, and a Gigabyte MB with the latest BIOS. Upgrading the BIOS did not change anything.

    _______________________________________________

    Sophos XG User