This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

WAN to LAN server

Hello,

I am attempting to route multiple WAN IP addresses to multiple internal LAN servers. For example, I have 10.1.1.10 as my primary MASQ route for all internet access. I created an alias on the same interface and used 10.1.1.11 which has a firewall rule pointing to 192.168.1.11. When I browse the internet from 192.168.1.11 I show my external IP is 10.1.1.10 however I need it to be 10.1.1.11. I tried creating another MASQ route but didn't see any change.

Any suggestions?

This thread was automatically locked due to age.

Parents

0 rfcat_vk over 4 years ago

You ned to point the gateway in your NAT policy at your alias.

Ian

XG115W - v20.0.3 MR-3 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel
0 Jay Kelly over 4 years ago in reply to rfcat_vk

I created a new outbound source (NAT Policy) and used the alias IP

But still have the same issue. Outbound traffic is coming from the default IP
Cancel
Vote Up 0 Vote Down

Cancel
0 rfcat_vk over 4 years ago in reply to Jay Kelly

Hi Jay,

is the 10 address your real external address or just n example? If it is the real address that means you have another modem performing NAT between the XG and the ISPs network.

Please provide a diagram of what you are trying to achieve and your network interface configuration.

Ian

XG115W - v20.0.3 MR-3 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel
0 Jay Kelly over 4 years ago in reply to rfcat_vk

Hello,

The 10 address was just an example. below is what I'm wanting to accomplish.

Each internal server should translate the external IP in/outbound traffic to the internal LAN.
Cancel
Vote Up 0 Vote Down

Cancel
0 rfcat_vk over 4 years ago in reply to Jay Kelly

Hi Jay,

thank you for the diagram, makes assistance so much easier.

Please try using WAF for your external facing servers.

Ian

XG115W - v20.0.3 MR-3 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 rfcat_vk over 4 years ago in reply to Jay Kelly

Hi Jay,

thank you for the diagram, makes assistance so much easier.

Please try using WAF for your external facing servers.

Ian

XG115W - v20.0.3 MR-3 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data