Important note about SSL VPN compatibility for 20.0 MR1 with EoL SFOS versions and UTM9 OS. Learn more in the release notes.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

WAN to LAN server

Hello,

I am attempting to route multiple WAN IP addresses to multiple internal LAN servers. For example, I have 10.1.1.10 as my primary MASQ route for all internet access. I created an alias on the same interface and used 10.1.1.11 which has a firewall rule pointing to 192.168.1.11. When I browse the internet from 192.168.1.11 I show my external IP is 10.1.1.10 however I need it to be 10.1.1.11. I tried creating another MASQ route but didn't see any change. 

 

Any suggestions?

 



This thread was automatically locked due to age.
Parents Reply Children
  • Hi Jay,

    is the 10 address your real external address or just n example? If it is the real address that means you have another modem performing NAT between the XG and the ISPs network.

    Please provide a diagram of what you are trying to achieve and your network interface configuration.

    Ian

    XG115W - v20.0.3 MR-3 - Home

    XG on VM 8 - v21 GA

    If a post solves your question please use the 'Verify Answer' button.

  • Hello,

    The 10 address was just an example. below is what I'm wanting to accomplish.

     

    Each internal server should translate the external IP in/outbound traffic to the internal LAN.

  • Hi Jay,

    thank you for the diagram, makes assistance so much easier.

    Please try using WAF for your external facing servers.

    Ian

    XG115W - v20.0.3 MR-3 - Home

    XG on VM 8 - v21 GA

    If a post solves your question please use the 'Verify Answer' button.