This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

NAT Inside Interface to OutSide Interface

Good Evening, I am running 3CX. My internal network is 172.16.10.0/24, but external is 192.168.0.0/24. I need to NAT 172.16.10.14/24 port 5001 to 192.168.0.50. I was able to get 192.168.0.50 active however it was only taking me to my XG for signin vs actually NAT'ing my internal device. Please help

This thread was automatically locked due to age.

Parents

0 rfcat_vk over 4 years ago

Hi,

please your firewall rule.

Your firewall should look like any - internal network -> any - > external network-> service port 5001 -> allow -> log

You will not need MASQ.

Ian

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 EAP

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel
0 Stephen Robertson over 4 years ago in reply to rfcat_vk

I tried that, I had to remove it, these are seperate interfaces, 172.16.10.x is on one interface and and 192.168.0.x is on another
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Stephen Robertson over 4 years ago in reply to rfcat_vk

I tried that, I had to remove it, these are seperate interfaces, 172.16.10.x is on one interface and and 192.168.0.x is on another
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 rfcat_vk over 4 years ago in reply to Stephen Robertson

Hi,

I suspect you have not explained your requirements very well.

The pointing an internal port at the XG external will not achieve anything.

The rule I suggested LAN, 172 network - WAN - 192 network port 5001 - allow - log will work.

What you are not saying is where the 3CX is and what connections does it offer ? 3CX from memory is a digital PABX which you appear to be trying to use to provide internet gateway functions?

Ian

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 EAP

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel