This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Gateway in Bridge mode

Am replacing and old CR50ia which is deployed in Bridge mode with a XG210 which am deploying in bridge mode as well. I have observed with the XG when the gateway status is down all LAN traffic can not go beyond it (bearing in mind its in bridge/transparent) but with the Cyberoam regardless of the appliance gateway status traffic will still flow through it. I know some static routes might be required but is that the case of the XG gateway status needs to up for traffic flow???

This thread was automatically locked due to age.

Parents

0 rfcat_vk over 6 years ago

For clarification, do you mean to other legs in the bridge?

Ian

XG115W - v20.0.3 MR-3 - on holiday

XGS118 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel
0 Mohammed Jabbie1 over 6 years ago in reply to rfcat_vk

Traffic from the LAN going through the appliance heading to the upstream gateway device.
Cancel
Vote Up 0 Vote Down

Cancel
0 rfcat_vk over 6 years ago in reply to Mohammed Jabbie1

I am sorry I don't think I understand? If the link i down no traffic wi flow through the bridge.

Ian

XG115W - v20.0.3 MR-3 - on holiday

XGS118 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel
0 Mohammed Jabbie1 over 6 years ago in reply to rfcat_vk

I mean if the appliance in bridge, the gateway on the appliance whether down or up, the appliance should still send traffic to the LAN gateway. Say for example my LAN is 192.168.0.0/24, and the gateway to this LAN is 192.168.0.1/24, I put XG between my LAN and gateway (192.168.0.1) assigning it an IP 192.168.0.2/24. If 192.168.0.1 is down shouldnt traffic still pass through from my LAN to the gateway after XG?
Cancel
Vote Up 0 Vote Down

Cancel
0 rfcat_vk over 6 years ago in reply to Mohammed Jabbie1

Depends on whether the WAN shows as being up in the GUI? If down nothing will pass.

Ian

XG115W - v20.0.3 MR-3 - on holiday

XGS118 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 rfcat_vk over 6 years ago in reply to Mohammed Jabbie1

Depends on whether the WAN shows as being up in the GUI? If down nothing will pass.

Ian

XG115W - v20.0.3 MR-3 - on holiday

XGS118 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 Mohammed Jabbie1 over 6 years ago in reply to rfcat_vk

But with the cyberoam the gateway status doesn't affect the traffic only in the XG. I will try adding static routes to see if that works.
Cancel
Vote Up 0 Vote Down

Cancel