Thread Info
  • State Verified Answer
  • Locked Locked
  • Replies 6 replies
  • Subscribers 0 subscribers
  • Views 19583 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

message relay

vospersIT

Hi all 

ok this is going to be a two part thing depending on what answers i get so first can you use a sum server as a message relay server or dose it need to be two diffrent servers.

:57904


This thread was automatically locked due to age.
Parents
  • 0

    Hello Kurt,

    was already a sum so iv eddited the mrinit.conf

    turning the SUM server into a relay this way worked up to SUM 1.5.1 - with 1.5.2 (and RMS 4.0) you must use the desired mrinit.conf at SUM install time. Don't despair yet :smileyhappy:

    Check your SUM's Current parent address (should point to your management server) and RMS router type by opening %ProgramData%\Sophos\Remote Management System\3\Router\NetworkReport\ReportData.xml. If the former is correct and the latter says endpoint (it hasn't converted to a message relay) then set the applicable registry keys to the values given in Enterprise Console: configuring message relay computers under Technical information. Restart the service and check ReportData.xml which hopefully now says message relay.

    HTH

    Christian

    :57921
Reply
  • 0

    Hello Kurt,

    was already a sum so iv eddited the mrinit.conf

    turning the SUM server into a relay this way worked up to SUM 1.5.1 - with 1.5.2 (and RMS 4.0) you must use the desired mrinit.conf at SUM install time. Don't despair yet :smileyhappy:

    Check your SUM's Current parent address (should point to your management server) and RMS router type by opening %ProgramData%\Sophos\Remote Management System\3\Router\NetworkReport\ReportData.xml. If the former is correct and the latter says endpoint (it hasn't converted to a message relay) then set the applicable registry keys to the values given in Enterprise Console: configuring message relay computers under Technical information. Restart the service and check ReportData.xml which hopefully now says message relay.

    HTH

    Christian

    :57921
Children
No Data
Unfiltered HTML