This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Port Range or any Port for a specific Ressource

Hi, 

Is it possible to add a Port Range or open any Port for a specific resource?

Our telephone system is using RTP ( All UDP >1024 ) Ports for Voice transportation. 

Regards,

Silvio



This thread was automatically locked due to age.
Parents
  • I found the answer in the known Bugs List. "Dynamic Portranges are not supported"

    Is the use of Dynamic Port range on the roadmap, or is it technical impossible?

  • Hi Silvio, While we can add multiple ports for a resource at the time of creating it, you cannot add a range of ports that would typically be needed in the case of VOIP resources. This is there as a part of our backlog.

    With respect to the second scenario, yes, as of now we do not support resources/applications that involve dynamic port allocation. As an admin, you need to define the actual ports that are going to be used at the time of creating resources. Which applications or protocols are you looking for that would potentially involve usage of dynamic ports?

Reply
  • Hi Silvio, While we can add multiple ports for a resource at the time of creating it, you cannot add a range of ports that would typically be needed in the case of VOIP resources. This is there as a part of our backlog.

    With respect to the second scenario, yes, as of now we do not support resources/applications that involve dynamic port allocation. As an admin, you need to define the actual ports that are going to be used at the time of creating resources. Which applications or protocols are you looking for that would potentially involve usage of dynamic ports?

Children