Thread Info
  • State Verified Answer
  • Locked Locked
  • Replies 8 replies
  • Subscribers 0 subscribers
  • Views 16782 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

pmx-queue-runner

guyver

I've just installed a new edge puremessage server.

I've got a problem with the queue-runner service. When i try to approve a message from quarantine manager or end user interface , the message go back in quarantine with reason queue and is not delivered.In pmx_log there are non errors or warning also if i set debug level to 15.

the only workaround i've found is disabling queue-runner service and using the old script pmx-queue.

is difficult do debug queue-runner because there is not much documentation about.

someone had the same problem ?

thank you

:5720


This thread was automatically locked due to age.
Parents
  • 0

    Can you release a message and monitor the pmx_log (it doesn't have to be in a high debug), and post the line of the release.

    I'd be curious to see what the r= in the pmx_log.

    I'd also be curious how you have localhost set up in your /etc/hosts.  Naming resolution may be sending the mail in the wrong direction.

    It would be ideal to send a support request in so an engineer can analyze your setup as there could be a few places where the issue may be.

    :5749
Reply
  • 0

    Can you release a message and monitor the pmx_log (it doesn't have to be in a high debug), and post the line of the release.

    I'd be curious to see what the r= in the pmx_log.

    I'd also be curious how you have localhost set up in your /etc/hosts.  Naming resolution may be sending the mail in the wrong direction.

    It would be ideal to send a support request in so an engineer can analyze your setup as there could be a few places where the issue may be.

    :5749
Children
No Data
Unfiltered HTML