Thread Info
  • State Verified Answer
  • Locked Locked
  • Replies 1 reply
  • Subscribers 0 subscribers
  • Views 7907 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Activating Windows products using ws1000

jongers

Hi,

We seem to have problems when trying to activate windows products over the internet using our ws1000.  When we attempt to do this get the following error from the Microsoft website  0x8004Fe33. 

The windows support website recommends changing the category for the following URLs

However the WS1000 already classifies these as Trusted sites. Has anyone else encountered similar problems while trying to activate windows products?

:2284


This thread was automatically locked due to age.
Parents
  • 0

    http://support.microsoft.com/kb/921471 says 0x8004FE33 may occur when you connect to the Internet through a proxy server where Basic* authentication is enabled.  To work around it, it says to disable Basic authentication.

    If Active Directory integration is enabled on your web appliance, then:

    1. Log on to the Administration Web Interface of your web appliance.
    2. Go to the Configuration > System > Active Directory page.
    3. Enable the Allow unauthenticated browsing for the following IU addresses option if it is not already enabled.
    4. Click Add.  Enter the IP address of the computer that you want to activate Windows.  Save the change.
    5. Click Apply.

    With these steps, the web appliance will not require your computer to authenticate before connecting to the Internet.  After Windows is activated, you can then remove the IP address from the list on the web appliance.

    * Our AD integration supports NTLM authentication only and not Basic authentication; however, both authentication schemes reply to the clients a message to provide credential information when they try to connect to the Internet.  It is this message that Windows Activation cannot handle.  Therefore, allowing unauthenticated browsing for the computer that you want to activate Windows should resolve the issue.

    Best Regards,
    P Parker, aka Ivan M

    :2290
Reply
  • 0

    http://support.microsoft.com/kb/921471 says 0x8004FE33 may occur when you connect to the Internet through a proxy server where Basic* authentication is enabled.  To work around it, it says to disable Basic authentication.

    If Active Directory integration is enabled on your web appliance, then:

    1. Log on to the Administration Web Interface of your web appliance.
    2. Go to the Configuration > System > Active Directory page.
    3. Enable the Allow unauthenticated browsing for the following IU addresses option if it is not already enabled.
    4. Click Add.  Enter the IP address of the computer that you want to activate Windows.  Save the change.
    5. Click Apply.

    With these steps, the web appliance will not require your computer to authenticate before connecting to the Internet.  After Windows is activated, you can then remove the IP address from the list on the web appliance.

    * Our AD integration supports NTLM authentication only and not Basic authentication; however, both authentication schemes reply to the clients a message to provide credential information when they try to connect to the Internet.  It is this message that Windows Activation cannot handle.  Therefore, allowing unauthenticated browsing for the computer that you want to activate Windows should resolve the issue.

    Best Regards,
    P Parker, aka Ivan M

    :2290
Children
No Data
Unfiltered HTML