This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

My webserver not respons

Hey!

Have an Windows Server 2012 R2 an webserver with wordpress.
Could not show page on that homepage.
have an domainname on that too
runing UTM now with Sophos Home edtion!
I Think must do an rule in NAT or is wrong place

This thread was automatically locked due to age.

0 BAlfson over 10 years ago

Do you see anything related when you try #1 in Rulz?

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 gytepr over 10 years ago

Hey!
yes my port 80 is open and an plugin in i wordpress says my site is upp and going.
but tryed My Blog | Just another WordPress site and says:
This page can’t be displayed

•Make sure the web address My Blog | Just another WordPress site is correct.
•Look for the page with your search engine.
•Refresh the page in a few minutes.

have done DNAT rule
traffic from : any
using service: http
going to :Extrernal WAN
Action:
destination to webserver(192.168.x.x)
and the service to: http

used these link:
How to Port Forward Service Ports with NAT: Astaro Security Gateway

but not sure something more must do i Think.
Cancel
Vote Up 0 Vote Down

Cancel
0 Amodin over 10 years ago

Remove the "and the service to: http", it is not necessary, leave it blank.

OPNSense 64-bit | Intel Xeon 4-core v3 1225 3.20Ghz
16GB Memory | 500GB SSD HDD | ATT Fiber 1GB
(Former Sophos UTM Veteran, Former XG Rookie)
Cancel
Vote Up 0 Vote Down

Cancel