Thread Info
  • State Verified Answer
  • Locked Locked
  • Replies 39 replies
  • Subscribers 8 subscribers
  • Views 64468 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IPSec VPN keeps down after DSL lines reconnects...

zaphod

i run several ipsec tunnel for years without any problems... all runs fine with 9.355-1


since the update to 9.402-7 all ipsec tunnels are down every morning.


i checked the ipsec-logs and found out that after my dsl-lines reconnect the tunnels will not come up again.

i have to turn them off and on and then all works....


anyone can help?



This thread was automatically locked due to age.
Parents
  • 0
    I have the same problem since updating to 9.402-7. I have 3 Uplink Interfaces (1 DSL, 2 Static IP). The IPsec Tunnel connects to the DSL-Line. After the daily DSL disconnect the IPsec-Tunnel doesn't come up again. When I disable the two other interfaces and then disable/enable the IPsec connections, the tunnel comes up and i can enable the two other interfaces again. Looks like the IPsec doesn't "know" which interface should be used as gateway.
Reply
  • 0
    I have the same problem since updating to 9.402-7. I have 3 Uplink Interfaces (1 DSL, 2 Static IP). The IPsec Tunnel connects to the DSL-Line. After the daily DSL disconnect the IPsec-Tunnel doesn't come up again. When I disable the two other interfaces and then disable/enable the IPsec connections, the tunnel comes up and i can enable the two other interfaces again. Looks like the IPsec doesn't "know" which interface should be used as gateway.
Children
No Data
Unfiltered HTML