This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Link Aggregation - How does it work?

Hello,

Can I have more information about link aggregation possibilities of my Sophos SG 210?

Does it use LACP? Is it different mode? Is it active/passive?

Manual is not very well explained :/

Regards,

DeltaSM

This thread was automatically locked due to age.

0 Scott_Klassen over 9 years ago

Yes it uses LACP. UTM adheres to the IEEE 802.3ad standards for link aggregation.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel
0 DeltaSM over 9 years ago

Thanks

Are the ports active or passive?
Cancel
Vote Up 0 Vote Down

Cancel
0 Scott_Klassen over 9 years ago

Active or Passive. Set the Cisco side to Active and it should work fine.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel