Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 11 replies
  • Subscribers 5 subscribers
  • Views 20680 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Show running configuration from shell?

GordonSS
I'm looking to see the full running configuration when logged in using SSH - something like an equivelant to Cisco's 'show running-config' or Juniper's 'show config'.

Can this be done with the UTM?


This thread was automatically locked due to age.
Parents
  • 0
    My suggestion was that a single change in WebAdmin can result in lots of changes to the configuration.  If Prefetch is enabled to sync new users, the configuration will change when they're added automatically.

    If you can't get the information out of the PostgreSQL database of recent changes, then the best you'll probably be able to do is get a message that says there's been a change so that you know to check the recent changes in WebAdmin.

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Reply
  • 0
    My suggestion was that a single change in WebAdmin can result in lots of changes to the configuration.  If Prefetch is enabled to sync new users, the configuration will change when they're added automatically.

    If you can't get the information out of the PostgreSQL database of recent changes, then the best you'll probably be able to do is get a message that says there's been a change so that you know to check the recent changes in WebAdmin.

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Children
No Data
Unfiltered HTML