This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

AP100 and APX530 powered through a PoE switch can't work!

We are connecting 3 AP100 and 1 APX530 to a PoE switch

https://www.rubytech.com.tw/rubytech/psgs-2852xbf/

But the switch shows them as the invalid PD. All of the ports with the AP connected have been with the max power 30W, can I know the possible root cause?

Thank you!

Rox

This thread was automatically locked due to age.

Parents

0 LHerzog over 3 years ago

Hi, from the tech specs it should work. Did you test plugging the AP directly with a short, new shielded cable to the switch port without the building wiring?
Cancel
Vote Up 0 Vote Down

Cancel
0 Rox Liao over 3 years ago in reply to LHerzog

Thank you so much! We will find the chance to have a try. But can I know why the suggestion?
Cancel
Vote Up 0 Vote Down

Cancel
0 LHerzog over 3 years ago in reply to Rox Liao

Invalid PD would indicate some issue with the power consumption. Maybe configuration issue on the switch, maybe something caused by faulty wiring to the AP. Hard to say from here.

Are other APs OK on that switch? How about other PoE devices with PoE+ 802.3at? Do they work?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 LHerzog over 3 years ago in reply to Rox Liao

Invalid PD would indicate some issue with the power consumption. Maybe configuration issue on the switch, maybe something caused by faulty wiring to the AP. Hard to say from here.

Are other APs OK on that switch? How about other PoE devices with PoE+ 802.3at? Do they work?
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data