Important note about SSL VPN compatibility for 20.0 MR1 with EoL SFOS versions and UTM9 OS. Learn more in the release notes.

Thread Info
  • State Not Answered
  • +1 person also asked this people also asked this
  • Locked Locked
  • Replies 7 replies
  • Subscribers 40 subscribers
  • Views 10701 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Active/Backup WAN setting option creates MAJOR Latency on Primary WAN Interface.

Aaron Cirilo

XG230 16.01.2

We have two WAN connections--PORT2(AT&T), PORT3(Newwave).  We are desire to remove traffic from PORT3 due to instablity of the connection. As well as trying to troubleshoot existing randon network issues.

So if I go to "Configure> Network> WAN Link Manager and attempt to edit and change to PORT 3 connection to TYPE=Backup.. then I get huge packet loss on my PORT2 connection.

 

We have removed every firewall rule from load balancing .. or using New wave as a Gateway.. yet we still have as much traffic per the graphs on PORT3 as PORT2 Not sure how to stop using NewWave without killing our traffic on ATT? Any ideas?



This thread was automatically locked due to age.
Parents Reply
  • 0 in reply to lferrara

    I removed it.. still bad

    I rebooted .. still bad

    I removed HA(High Availablity) with PORT 3 unconfigured... GOOD.

    I configure PORT 3 without HA.... bad.

    I remove PORT 3 ..reboot with HA.. good for a little bit.. now bad.

    I turned off IPS.. because CPU was very high... back to ok.

    ... this is my bandwidth monitor on CLI of Sophos..

    PORT 1 = LAN PORT 2 is WAN.. How is so much traffic happing on PORT2 without it being coming from our LAN?

     

Children
Unfiltered HTML