We have been using the 9.x UTM's for a while now, and just got our first XG today. I am setting up this XG with a 4 port LAG to an internal switch. I have created 5 VLAN's and 5 Zones. On the switch I have the LAG built and I see it come up.
The LAG on the switch is set to tag for all the VLANs associated with it.
I then go and assign an IP on my laptop and put it on a port on the switch assigned to the appropriate VLAN. At this point, I just want to try to ping the VLAN IP I assigned on the Sophos...it fails.
Because I can't even get this basic L2 traffic passing, it indicates I am just not aware of the correct way to configure this on the XG's compared to how we did it on the 9.x UTM's.
Just curious if anybody could share with me the minimal configuration necessary to go from a new UTM to basic VLAN-> Switch Trunk setup to verify L2 on the new XG firewalls.
This thread was automatically locked due to age.
