Starting with Wireless AP and Sophos XG

Roberto,

if you delete this DHCP and you enable DHCP on the LAN interface, does the dhcp server service start?

Also, the AP is on a separate zone and not bridged to LAN as the IP is different, correct?

Thanks

Hi lferrara

1) Yes, If i enable a dhcpserver on a LAN interface the server start succesfully but the dhcp does not runs on wlan

DHCPD_PORTS 'wlnet1,lag0.11'
Adding interface 'wlnet1'
Adding interface 'lag0.11'
Internet Systems Consortium DHCP Server 4.3.6-P1
Copyright 2004-2018 Internet Systems Consortium.
All rights reserved.
For info, please visit www.isc.org/.../
Config file: /cfs/system/dhcp/dhcpd.conf
Database file: /tmp/dhcpd.leases
PID file: /var/run/dhcpd.pid
Wrote 0 leases to leases file.
write_lease: JSON: <{ "filename":"/tmp/dhcpd.leases", }>

write_lease: OPCODE <write_dhcp_lease> executed successfully

Listening on LPF/lag0.11/00:e0:20:ac:b5:05/lag0.11
Sending on   LPF/lag0.11/00:e0:20:ac:b5:05/lag0.11

No subnet declaration for wlnet1 (no IPv4 addresses).
** Ignoring requests on wlnet1.  If this is not what
   you want, please write a subnet declaration
   in your dhcpd.conf file for the network segment
   to which interface wlnet1 is attached. **

Sending on   Socket/fallback/fallback-net

2) Yes, the idea is to use lan connection we have in all our buildings but connect wireless on a dmz

Are you running latest XG firmware version?

I will try to configure separate ap on my lab and let you know if dhcp starts.

Regards

Are you running latest XG firmware version?

I will try to configure separate ap on my lab and let you know if dhcp starts.

Regards

Yes, running XG330 (SFOS 17.5.9 MR-9)

Regards

Roberto

Roberto,

I tried on my lab (v18) and DHCP works as expected. Take note I did not delete the bridge to AP SSID.

DHCP is already started and creating a new SSID (separate) will just reload the dhpc service and assign IPs.

Can you try to create a SSID "bridge to AP LAN" and then create a separate AP zone and check if it works?

Thanks

if i understand : for do this i must connect the AP to another zone/port and this (in this moment) can't be done..

(PS in my LAN i already have another dhcp server (a Windows Server) if i bridge to APLan the AP15 i can connect and receive an ip address from this dhcp)

Roberto,

if you create the Bridge to AP lan, the XG will create the new SSID on the same LAN interface where the AP is connected.

This is not a big problem, as the AP will have an ip on the LAN zone and you can create a DHCP that leases only 1 ip.

Once you have done this step, you can create the "create separate zone" and try if DHCP works as expected.

Regards

No, can't run in this way as it get the address from the dhcp already existing on the LAN.

OK, found the clue.

For some weird weird reason the virtual wlan network interface to which the AP was connected gone "sciroppata"  (broken, lost all parameters), created completely new interface, new dhcp server and not it works. :-)

now i must only find the way to delete this interface

Thanks for the support

Roberto