Problem configuring DHCP Relay in XG 17

Question

Hi all, 
 After using XG17 now for some months in gateway mode / route mode, I was wondering how to put this firewall into bridge mode / gateway mode. 
 
 Do I only need to enable DHCP Relay to convert XG to bridge mode, or is it better to do a factory reset and then select bridge mode in the wizard? 
 
 I put DHCP Relay on (after following the guidance on sophos.com), but the clients on the inside don't seem to receive an IP adress. 
 
 Am I missing something?

lferrara · Accepted Answer

MKR74, 
 Where is the dhcp server? 
 Check this kb: 
 
 Regards

lferrara · Answer

Please let us know. 
 Thanks

MKR74 · Answer

Hi lferrara, 
 
 I reset the device and I used the wizard to configure it as a transparant bridge. 
 
 It worked immediately, even without configuring DHCP relay.