Important note about SSL VPN compatibility for 20.0 MR1 with EoL SFOS versions and UTM9 OS. Learn more in the release notes.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 38 subscribers
  • Views 12800 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IPv6 configuration on WAN

Matt_NZ

So, I thought I'd see about doing a manual move from UTM 9 to XG but I'm a little stuck when it comes to replicating my IPv6 setup that I have in UTM.

Here's what I have in UTM:

But in XG, if I choose static then I have to manually enter a Gateway IP as well.  Any IPs I enter that look to be my ISP's IPv6 gateway gives me a error saying that I can't enter a broadcast IP.  Am I doing something wrong here?



This thread was automatically locked due to age.
  • 0
    Hi MattWilliams,
    Make sure the Netmask you use matches your providers netmask for the IPv6 address. Common Netmasks, also called prefix lengths for IPv6, for a static assignment are /64, /56 and /48. If all else fails, try calling your provider and ask them what gateway address you should use.
  • 0

    Your provider might also be using a /128 for your link.

    Please check.
    ian

    Putting on my glasses shows you are already at /128.

    I am currently trying to get a sixxs /64 external tunnel to work. Needs a login, but there is nowhere to put id and password.

    ian

    Your ISP might have provided you with a /128 for your end, try using the ISP end address as your gateway. As it is a /128 it will be one address either side of your allocated address.

    XG115W - v20.0.2 MR-2 - Home

    XG on VM 8 - v21 GA

    If a post solves your question please use the 'Verify Answer' button.

Unfiltered HTML