Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 1 subscriber
  • Views 1153 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Shield icon - "update failed" indication

QC

I noticed yesterday that the shield icon does not "immediately" indicate an update failure with the white-on-red cross. It looks like it takes about an hour until the overlay appears. There's also no pop-up before that but the tooltip correctly indicates the failed update. The Changes to the shield icon ... article makes no mention of this.

Christian

:7061


This thread was automatically locked due to age.
Parents
  • 0

    The change in only alerting to a failed update after 1 hour is a good thing in my opinion.  Especially if a machine takes a while to get an IP for whatever reason, no one is alarmed falsely.

    If you are not notified at the first failure when using a short interval or if the "initial" update fails it is probably a good thing. OTOH it might delay detection of a more general issue (who is constantly monitoring SEC :smileywink:?). If it is really one hour then it should be documented (if it is configurable this too should be published).

    Christian

    :7101
Reply
  • 0

    The change in only alerting to a failed update after 1 hour is a good thing in my opinion.  Especially if a machine takes a while to get an IP for whatever reason, no one is alarmed falsely.

    If you are not notified at the first failure when using a short interval or if the "initial" update fails it is probably a good thing. OTOH it might delay detection of a more general issue (who is constantly monitoring SEC :smileywink:?). If it is really one hour then it should be documented (if it is configurable this too should be published).

    Christian

    :7101
Children
No Data
Unfiltered HTML