Thread Info
  • State Verified Answer
  • +1 person also asked this people also asked this
  • Locked Locked
  • Replies 4 replies
  • Subscribers 12 subscribers
  • Views 3045 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Registration Issue

MatthewShafer

I recently ran into an issue with registering a new AP 55.  I did not have the correct ports open on my UTM, and thus registration would fail.  After multiple attempts, I realized my issue and opened the correct ports.  When I proceeded to register the device, it hung on the registration screen and never showed a successful registration.  After approximately 15 minutes, I tried to close out of the registration.  I think that it said that I could not do it, and then took me back and showed that the access point was online.  Anyone else seen this kind of behavior?



This thread was automatically locked due to age.
Parents
  • 0

    Hi Matthew,

    can you remember if the registration screen showed multiple access point entries?

    Above the one that had the issue?

    Regards Michael

  • 0 in reply to MichaelPlewan

    When I was setting up this particular access point, it was the only access point that I was trying to register.  It did not show it multiple times, but after the first time it failed, I had the retry button on the right.  Does that answer your question?

    Also, today I deployed 4 more access points.  This one was a multiple registration, and when I clicked retry on the failed access point, I got the attached screenshot.

    <Image removed by Sophos>

    The bottom access point that is registering (the one without the serial number) is from when I clicked retry on the top failed one.

  • 0 in reply to MatthewShafer

    Yes that helps and we have these issues tracked under CWIFI-4192 and CWIFI-4184.

    Best regards,

    Michael

Reply Children
Unfiltered HTML