This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Rack Mount Kit for Sophos XGS 126

Has anyone ran into the Rack mount kit for the XGS 126 holes not lining up. If you screw in the front, the rear 2 do not line up. If you do the opposite, the front hole will not line up. See attached picture as an example

I double checked and we do have the correct mounts for this Firewall.

This thread was automatically locked due to age.

Top Replies

FFin 9 months ago +1 suggested

In the original packet there are 4 Rackmount-Plates. You need two of them. Which ones depend on mounting direction. Back to front or front to front. You have a closer look into instructions and probably…

0 dirkkotte 9 months ago

Are you sure, this is a XGS125 RMK?

https://docs.sophos.com/nsg/hardware/mountingInstructions/sophos-rackmount-kit-mounting-instructions-xgs-116-116w-126-126w-136-136w_2020-12-16.pdf

Dirk

Systema Gesellschaft für angewandte Datentechnik mbH // Sophos Platinum Partner
Sophos Solution Partner since 2003
If a post solves your question, click the 'Verify Answer' link at this post.
Cancel
Vote Up 0 Vote Down

Cancel
0 FFin 9 months ago

In the original packet there are 4 Rackmount-Plates. You need two of them. Which ones depend on mounting direction. Back to front or front to front. You have a closer look into instructions and probably try the other two parts! It will be correctly aligned, once figured out!
Cancel
Vote Up +1 Vote Down

Cancel
0 Don Paul 9 months ago in reply to FFin

Ok, going over this again. I was doing this onsite, in a tight space and that was one issue I had. The mounting preference due to the way it was being mounted would be in diagram 2b of the instructions. It was a vertical mount, and I wanted the ports to be facing up to be easily accessible. So for me, that would have been the "front" however, I am guessing I am incorrect there. Therefore I put the "small bracket", which now I see is marked as "right", on the side I felt was the "right side". Are you saying that small bracket should be on the other side, and the large wide mounting bracket with the adapter tray be on the other?
Cancel
Vote Up 0 Vote Down

Cancel
0 dirkkotte 9 months ago in reply to Don Paul

the ports are on the back

Dirk

Systema Gesellschaft für angewandte Datentechnik mbH // Sophos Platinum Partner
Sophos Solution Partner since 2003
If a post solves your question, click the 'Verify Answer' link at this post.
Cancel
Vote Up 0 Vote Down

Cancel