Thread Info
  • State Verified Answer
  • Locked Locked
  • Replies 10 replies
  • Subscribers 40 subscribers
  • Views 3168 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Installes Software-Appliance-Image in old XG105 no ping to 172.16.16.16 and no DHCP

Sebastian Wittmann

Good morning,

I installed the Software-Appliance Image on an old XG105, to use it at home with the Home Use Licence. 

Now the appliace is starting and I can login with display and keybord. LAN1 is on, but I can not ping 172.16.16.16. And I did not get a DHCP address. 

Very strange.

Where is my fault?

Thanks a lot,

Sebastian



This thread was automatically locked due to age.
Parents
  • 0

    If you install the software Image, it could be a different port setting than expected. 

    Use the console to verify the ports: ethtool eth0 / eth1 / eth2 etc. 

    Check which Port is currently connect and go one by one to see, if the order is mixed up. 

    __________________________________________________________________________________________________________________

Reply
  • 0

    If you install the software Image, it could be a different port setting than expected. 

    Use the console to verify the ports: ethtool eth0 / eth1 / eth2 etc. 

    Check which Port is currently connect and go one by one to see, if the order is mixed up. 

    __________________________________________________________________________________________________________________

Children
Unfiltered HTML